Editing Argon user guide/Mating connectors and accessories
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 113: | Line 113: | ||
*{{Farnell|2211821}} | *{{Farnell|2211821}} | ||
|} | |} | ||
− | + | ||
=Heat sinks & cooling & high power application= | =Heat sinks & cooling & high power application= | ||
Line 153: | Line 153: | ||
==[[Argon user guide/Braking resistor|Braking resistors]]== | ==[[Argon user guide/Braking resistor|Braking resistors]]== | ||
{{tip|One resistor in a multiaxis system may be sufficient if drives are [[Argon_user_guide/J4_connector_wiring|wired to share the HV DC bus between them]]}} | {{tip|One resistor in a multiaxis system may be sufficient if drives are [[Argon_user_guide/J4_connector_wiring|wired to share the HV DC bus between them]]}} | ||
− | {{tip|In most installations braking resistor is not needed at all. Resistor is needed in cases where fast moving motor with high inertial load is stopped rapidly causing conversion of the kinetic energy into electric current which needs to be dissipated by a resistor. Experimenting without resistor is safe as drive's overvoltage protection will prevent any damage occurring. If drive faults to overvoltage fault during deceleration, then try adjusting | + | {{tip|In most installations braking resistor is not needed at all. Resistor is needed in cases where fast moving motor with high inertial load is stopped rapidly causing conversion of the kinetic energy into electric current which needs to be dissipated by a resistor. Experimenting without resistor is safe as drive's overvoltage protection will prevent any damage occurring. If drive faults to overvoltage fault during deceleration, then try adjusting [[FOV]] to higher value or add a braking resistor.}} |
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
Line 166: | Line 166: | ||
*[[Granite Devices web shop|GD web shop]] | *[[Granite Devices web shop|GD web shop]] | ||
*{{digikey|A102370-ND}} | *{{digikey|A102370-ND}} | ||
− | |||
− | |||
− | |||
|} | |} |