Editing SimuCUBE pinouts and wiring
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 202: | Line 202: | ||
Please note, that if, for whatever reason, the internal resistor on the SimuCUBE has cracked, the steps listed [[SimuCUBE troubleshooting]] should be performed to analyze the health of the MOSFET transistor. | Please note, that if, for whatever reason, the internal resistor on the SimuCUBE has cracked, the steps listed [[SimuCUBE troubleshooting]] should be performed to analyze the health of the MOSFET transistor. | ||
− | On SimuCUBE | + | On SimuCUBE Hardware Revision 2, the pinout of the external resistor connection has changed compared to the above image. Please refer to the markings on the SimuCUBE board. |
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
Line 211: | Line 211: | ||
| External || Remove jumper and connect external resistor between '''Resistor Input''' and '''HV BUS Output''' || | | External || Remove jumper and connect external resistor between '''Resistor Input''' and '''HV BUS Output''' || | ||
|} | |} | ||
− | |||
− |