Editing Splitting encoder signal
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 6: | Line 6: | ||
*Optoisolators: H11L1 (support frequency up to 500 kHz) | *Optoisolators: H11L1 (support frequency up to 500 kHz) | ||
*Resistors: 1 kOhm | *Resistors: 1 kOhm | ||
− | |||
{{picturebox|Encodersplitternoniso.png|caption=Splitting encoder signals without isolation. Note: if long cables used (>3m), then termination of encoder differential pairs (A+ to A- etc) may be necessary with 120 ohm resistors at the drive/controller end.}} | {{picturebox|Encodersplitternoniso.png|caption=Splitting encoder signals without isolation. Note: if long cables used (>3m), then termination of encoder differential pairs (A+ to A- etc) may be necessary with 120 ohm resistors at the drive/controller end.}} | ||
− | |||
− | |||
− |