Granity user guide/Connect
This dialog serves following purposes:
- Connecting and disconnecting to drive
- Loading and saving settings
- Clear drive fault state
Connecting
Preparations
In order to establish a connection from PC to drive, ensure that drive is wired properly. Minimum requirements for connection:
- Argon drive
- 24VDC logic power applied to drive
- Drive connected to PC via RS485 interface (such as SimpleMotion V2 USB adapter)
- Drive address DIP switches configured to give an unique address for drive
[kuva]
Establishing connection
Once all hardware has been connected and powered, use following procedure to connect:
- Choose your Communication interface device from dropdown list
- Choose Device address that equals to the drive's DIP switch setting
- Click Apply to connect
Troubleshooting
- Check if [drive led blinking sequence] is indicating an error
- Check address matching
- Ensure correct interface device has been selected
- Ensure that bus termination DIP setting has been turned on only on the last drive in the bus
In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.
As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.
Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.
