Argon EXT connector

From Granite Devices Knowledge Wiki
Revision as of 11:37, 6 May 2015 by Tero K (Talk | contribs) (Simulated encoder output)


Jump to: navigation, search

Argon (servo drive) has an internal 6 pin header that is directly connected to the I/O side user programmable STM32F205RBT6 microcontroller. EXT connector has several purposes:

  • MCU debugging port (SWD)
  • Extension board connector (5V power supply and I/O & UART to extension board)
  • Simulated encoder output port (i.e. output resolver position in quadrature format)

Pinout

Argonpcbextconn.png

Location of EXT connector


Argonextconn.png

Pin numbering and default hardware peripheral names on MCU

Simulated encoder output

From Argon firmware 1.5.0 version, the default function of EXT connector is an simulated encoder output. The pins will output quadrature signals to represent the position changes on feedback device (encoder, resolver etc).

Features
  • Output A,B,Z 3.3 volt signals
  • Minimum output pulse length 1 µs (requirement for receiving device to accept count rate of 2 MHz)
  • Output resolution is divided by 4 compared to the native resolution of the feedback device
Limitations
  • Output has lots of jitter (will look ugly on oscilloscope)
  • Index pulse has up to 1ms delay from the real index pulse location. EXT index pulse should be used for homing at very low speeds only (speed less than 1000 of feedback device counts per second)
  • No ESD protection, external buffer or protection circuit highly recommended
  • Maximum output count rate 300 000 counts/s
Pinout of encoder simulation
  1. GND
  2. 5V_OUT (leave unconnected if not needed)
  3. A
  4. B
  5. Z (index)
  6. Not in use, do not connect

In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.