Editing Argon user guide/J5 connector electrical interfacing
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 179: | Line 179: | ||
To operate the motor, limit switches must be connected to the GPI1 and GPI2. Feeding logic 1 to one of these ports enables axis motion feed in certain direction. | To operate the motor, limit switches must be connected to the GPI1 and GPI2. Feeding logic 1 to one of these ports enables axis motion feed in certain direction. | ||
− | The behavior of feed enable signals can be configured via [[Granity user guide/Machine|Granity machine tab]]. Logic 1 to these pins is required for drive operation: | + | The behavior of feed enable signals can be configured via [[Granity user guide/Machine|Granity machine tab]]. Logic 1 will enable the feed. Logic 1 to these pins is required for drive operation: |
*GPI1 - enable positive direction feed. | *GPI1 - enable positive direction feed. | ||
*GPI2 - enable negative direction feed. | *GPI2 - enable negative direction feed. | ||
Line 230: | Line 230: | ||
− | + | ||
===Complete example with pulse & direction=== | ===Complete example with pulse & direction=== |