Editing Argon user guide/Wiring
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 15: | Line 15: | ||
# 24 VDC wiring to port J3 | # 24 VDC wiring to port J3 | ||
# [[Safe torque off]] and enable signals to port J2. See [[SimpleMotion V2 port|how]]. | # [[Safe torque off]] and enable signals to port J2. See [[SimpleMotion V2 port|how]]. | ||
− | # Motion [[controller]] wiring | + | # Motion [[controller]] wiring to port J5 if pulse & direction, analog, PWM or quadrature setpoint signal used. If controlled SimpleMotion V2 bus, then a cable from [[SimpleMotion V2 compatible communication interface device]] to J2 |
− | + | ||
− | + | ||
# Axis limit [[Argon user guide/J5 connector electrical interfacing|switches wired to port J5]] | # Axis limit [[Argon user guide/J5 connector electrical interfacing|switches wired to port J5]] | ||
# [[Feedback devices|Feedback device]] wiring to port J1 | # [[Feedback devices|Feedback device]] wiring to port J1 | ||
Line 83: | Line 81: | ||
===Wiring of single drive=== | ===Wiring of single drive=== | ||
[[File:Argonwiringoverview.png|800px]] | [[File:Argonwiringoverview.png|800px]] | ||
− | |||
− |