Difference between revisions of "DIY SimpleMotion V2 adapter"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
 
(4 intermediate revisions by the same user not shown)
Line 1: Line 1:
<gallery>
+
It is possible to build [[SimpleMotion V2 compatible communication interface device]] from commonly available parts. This article gives instructions of making one from the parts listed below.
File:IMAG1584.jpg|Needed parts (sold as kit)
+
 
 +
*1pcs FTDI's USB to RS485 adapter cable, [http://www.ftdichip.com/Products/Cables/USBRS485.htm USB-RS485-WE-1800-BT]
 +
*1pcs Non-cross linked RJ45 cable (cable will be cut, so one cable is good up to two adapters)
 +
*2pcs 620 to 680 ohm leaded resistors
 +
*1pcs 6 pole terminal block
 +
*1pcs cable tie
 +
 
 +
These parts are available from most electronics component distributors, such as Farnell, Mouser and Digikey.
 +
==Assembly guide==
 +
<gallery widths=400 heights=400>
 +
File:IMAG1584.jpg|Needed parts
 
File:IMAG1581.jpg|Needed tools
 
File:IMAG1581.jpg|Needed tools
 
File:IMAG1582.jpg|Stripping insulation of RJ45 cable
 
File:IMAG1582.jpg|Stripping insulation of RJ45 cable
Line 8: Line 18:
 
File:IMAG1589.jpg|Final product
 
File:IMAG1589.jpg|Final product
 
</gallery>
 
</gallery>
 +
==Troubleshooting==
 +
If connection to device do not work, or is unstable, check that all wires are well connected to the terminal block. Sometimes terminal block screw may be pressing on wire insulator preventing good electrical contact. Try reconnecting wires if trouble persists.

Latest revision as of 11:13, 17 September 2015

It is possible to build SimpleMotion V2 compatible communication interface device from commonly available parts. This article gives instructions of making one from the parts listed below.

  • 1pcs FTDI's USB to RS485 adapter cable, USB-RS485-WE-1800-BT
  • 1pcs Non-cross linked RJ45 cable (cable will be cut, so one cable is good up to two adapters)
  • 2pcs 620 to 680 ohm leaded resistors
  • 1pcs 6 pole terminal block
  • 1pcs cable tie

These parts are available from most electronics component distributors, such as Farnell, Mouser and Digikey.

Assembly guide[edit | edit source]

Troubleshooting[edit | edit source]

If connection to device do not work, or is unstable, check that all wires are well connected to the terminal block. Sometimes terminal block screw may be pressing on wire insulator preventing good electrical contact. Try reconnecting wires if trouble persists.