Difference between revisions of "DIY SimpleMotion V2 adapter"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
Line 1: Line 1:
 +
It is possible to build [[SimpleMotion V2 compatible communication interface device]] from commonly available parts. This article gives instructions of making one from the parts listed below.
 +
 +
*1pcs FTDI's USB to RS485 adapter cable, [http://www.ftdichip.com/Products/Cables/USBRS485.htm USB-RS485-WE-1800-BT]
 +
*1pcs Non-cross linked RJ45 cable (cable will be cut, so one cable is good up to two adapters)
 +
*2pcs 620 to 680 ohm leaded resistors
 +
*1pcs 6 pole terminal block
 +
*1pcs cable tie
 +
==Assembly guide==
 
<gallery widths=400 heights=400>
 
<gallery widths=400 heights=400>
 
File:IMAG1584.jpg|Needed parts (sold as kit)
 
File:IMAG1584.jpg|Needed parts (sold as kit)

Revision as of 11:08, 17 September 2015

It is possible to build SimpleMotion V2 compatible communication interface device from commonly available parts. This article gives instructions of making one from the parts listed below.

  • 1pcs FTDI's USB to RS485 adapter cable, USB-RS485-WE-1800-BT
  • 1pcs Non-cross linked RJ45 cable (cable will be cut, so one cable is good up to two adapters)
  • 2pcs 620 to 680 ohm leaded resistors
  • 1pcs 6 pole terminal block
  • 1pcs cable tie

Assembly guide