Difference between revisions of "DIY SimpleMotion V2 adapter"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
Line 8: Line 8:
 
==Assembly guide==
 
==Assembly guide==
 
<gallery widths=400 heights=400>
 
<gallery widths=400 heights=400>
File:IMAG1584.jpg|Needed parts (sold as kit)
+
File:IMAG1584.jpg|Needed parts
 
File:IMAG1581.jpg|Needed tools
 
File:IMAG1581.jpg|Needed tools
 
File:IMAG1582.jpg|Stripping insulation of RJ45 cable
 
File:IMAG1582.jpg|Stripping insulation of RJ45 cable

Revision as of 11:11, 17 September 2015

It is possible to build SimpleMotion V2 compatible communication interface device from commonly available parts. This article gives instructions of making one from the parts listed below.

  • 1pcs FTDI's USB to RS485 adapter cable, USB-RS485-WE-1800-BT
  • 1pcs Non-cross linked RJ45 cable (cable will be cut, so one cable is good up to two adapters)
  • 2pcs 620 to 680 ohm leaded resistors
  • 1pcs 6 pole terminal block
  • 1pcs cable tie

Assembly guide

Troubleshooting

If connection to device do not work, or is unstable, check that all wires are well connected to the terminal block. Sometimes terminal block screw may be pressing on wire insulator preventing good electrical contact. Try reconnecting wires if trouble persists.