Editing EMI suppression cores
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 27: | Line 27: | ||
[[File:Argon test stup closeup m.jpg|thumb|Correct installation of a core in 3 phase motor U,W and V wires and leaving PE wire out.]] | [[File:Argon test stup closeup m.jpg|thumb|Correct installation of a core in 3 phase motor U,W and V wires and leaving PE wire out.]] | ||
Application tips: | Application tips: | ||
− | * | + | *Make 2-3 turns of cable through one core to maximize it's effectiveness |
*Place core close to interference source, not in the middle of the cable | *Place core close to interference source, not in the middle of the cable | ||
− | |||
===With servo drives=== | ===With servo drives=== | ||
To solve an EMI problem its good to have selection of cores that can be tried on different cables. Most typical placement for cores: | To solve an EMI problem its good to have selection of cores that can be tried on different cables. Most typical placement for cores: | ||
Line 41: | Line 40: | ||
==See also== | ==See also== | ||
*[[Wikipedia:Ferrite bead]] | *[[Wikipedia:Ferrite bead]] | ||
− | |||
− | |||
− | |||
− |