Editing IONICUBE 1X connectors and pinouts
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 78: | Line 78: | ||
File:Ionicube mot step.png|Wiring of two phase stepping motor. Brake can be fitted like in the other examples. Also 6 and 8 wire motors can be wired (the two drive coils connect always to the same PHASE outputs). | File:Ionicube mot step.png|Wiring of two phase stepping motor. Brake can be fitted like in the other examples. Also 6 and 8 wire motors can be wired (the two drive coils connect always to the same PHASE outputs). | ||
</gallery> | </gallery> | ||
− | |||
− | |||
====Regenerative resistor==== | ====Regenerative resistor==== | ||
[[Regenerative resistor]] is optional and may be connected between REG and HV+ terminals. The on board transistor is capable of carrying max 10 Amp current on regenerative resistor, so ''minimum'' allowed resistance can be calculated from: R<sub>min</sub>=HV<sub>voltage</sub>/10. I.e. with 48VDC HV supply, the minimum resistance is 48V/10A = 4.8 Ohms. Suggested resistor power capability is 20-100 W. | [[Regenerative resistor]] is optional and may be connected between REG and HV+ terminals. The on board transistor is capable of carrying max 10 Amp current on regenerative resistor, so ''minimum'' allowed resistance can be calculated from: R<sub>min</sub>=HV<sub>voltage</sub>/10. I.e. with 48VDC HV supply, the minimum resistance is 48V/10A = 4.8 Ohms. Suggested resistor power capability is 20-100 W. | ||
Line 174: | Line 172: | ||
To mount in DIN rail, obtain 2 pcs of Phoenix Contact part number 1201578. Such part is available from many distributors including {{digikey|277-2296-ND}} | To mount in DIN rail, obtain 2 pcs of Phoenix Contact part number 1201578. Such part is available from many distributors including {{digikey|277-2296-ND}} | ||
{{picturebox|Ionicube1x dims.png|caption=Dimensions and mounting hole locations}}. | {{picturebox|Ionicube1x dims.png|caption=Dimensions and mounting hole locations}}. | ||
− | |||
− | |||
− |