Editing LinuxCNC
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 5: | Line 5: | ||
*Multiaxis G-code milling and turning | *Multiaxis G-code milling and turning | ||
*Can operate motor drives in open loop and closed loop mode | *Can operate motor drives in open loop and closed loop mode | ||
− | *Can close the position loop inside the software by reading axis position information via [[feedback devices]] and outputting velocity | + | *Can close the position loop inside the software by reading axis position information via [[feedback devices]] and outputting velocity setpoint to motor drives |
*Various [[setpoint signal]] devices supported including: | *Various [[setpoint signal]] devices supported including: | ||
**[[Pulse and direction]] | **[[Pulse and direction]] | ||
Line 13: | Line 13: | ||
==See also== | ==See also== | ||
* [[Using Argon with LinuxCNC]] | * [[Using Argon with LinuxCNC]] | ||
− | |||
− | |||
− | |||
− |