Difference between revisions of "Setpoint signal"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[unchecked revision][unchecked revision]
(Created page with "Reference signal refers to a signal or command that will be used as target value in control systems. Typical occurrences of reference signals in GD procuts are: * Position ref...")
 
Line 7: Line 7:
 
In practice, reference signals may have several representations in real world including:
 
In practice, reference signals may have several representations in real world including:
 
* Analog voltage signal
 
* Analog voltage signal
* Pulse/direction signals
+
* [[Pulse and direction]] signals
 
* [[PWM]] signal
 
* [[PWM]] signal
 
* Serial communication command
 
* Serial communication command
  
 
In these cases there will be a conversion between input and output units. For example when using +/-10V reference as velocity reference, the relation betveen types could be 1 Volt per 100 rpm (or any other scale).
 
In these cases there will be a conversion between input and output units. For example when using +/-10V reference as velocity reference, the relation betveen types could be 1 Volt per 100 rpm (or any other scale).

Revision as of 14:22, 26 March 2012

Reference signal refers to a signal or command that will be used as target value in control systems. Typical occurrences of reference signals in GD procuts are:

  • Position reference
  • Veloicty reference
  • Torque reference

I.e. position reference value may be "1234" which could mean a target position of 1234 mm in some linear actuator. Or torque reference of 5 Nm would mean that motor is asked to produce 5 Nm torque.

Physical reference signal types

In practice, reference signals may have several representations in real world including:

In these cases there will be a conversion between input and output units. For example when using +/-10V reference as velocity reference, the relation betveen types could be 1 Volt per 100 rpm (or any other scale).