Editing Simucube wireless wheel system
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 42: | Line 42: | ||
** Inputs modes and encoder types can be changed by only the button plate manufacturers and resellers via a separate hardware programming device and software. This is available from GD via request. | ** Inputs modes and encoder types can be changed by only the button plate manufacturers and resellers via a separate hardware programming device and software. This is available from GD via request. | ||
** Default mode for encoders is 1 pin state change per detent, i.e 1/4 gray code cycles per detent. | ** Default mode for encoders is 1 pin state change per detent, i.e 1/4 gray code cycles per detent. | ||
− | + | * '''Configuring the wireless button plate module is not possible''' without a programming device and software that is only available on request from Granite Devices to button plate manufacturers. '''Configuring is not supported for DIY purposes.''' | |
− | + | ||
==Simucube wireless adapter== | ==Simucube wireless adapter== | ||
Line 94: | Line 93: | ||
[[Media:Bt_board_breakout_1r1_gerber-2018-09-04.zip|Gerber files for reference break out board]] | [[Media:Bt_board_breakout_1r1_gerber-2018-09-04.zip|Gerber files for reference break out board]] | ||
− | |||
− |