Editing Using stepping motor with IONI
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 8: | Line 8: | ||
:In this mode, a stepping motor is used as high pole count brushless servo motor. In this mode, motor efficiency is high (no current if no load) and motor do not lose synchronism. However, motor speed is limited by back EMF of motor and typically can achieve lower top speed than the other modes. In this mode stepper can be also safely driven over it's rated current to get higher peak torque than it's rated torque (like a servo motor). | :In this mode, a stepping motor is used as high pole count brushless servo motor. In this mode, motor efficiency is high (no current if no load) and motor do not lose synchronism. However, motor speed is limited by back EMF of motor and typically can achieve lower top speed than the other modes. In this mode stepper can be also safely driven over it's rated current to get higher peak torque than it's rated torque (like a servo motor). | ||
− | In the modes 1 and 2 stepper is driven with constant current drive and the motion produced by adjusting phase angle (traditional stepper drive method) | + | In the modes 1 and 2 stepper is driven with constant current drive and the motion produced by adjusting phase angle (traditional stepper drive method). In the mode 3 motor current is controlled by torque controller (from zero to peak current limit) while phase angle is synchronized to rotor angle by the help of encoder. |
==Setting up open loop mode 1== | ==Setting up open loop mode 1== | ||
Line 90: | Line 90: | ||
# Some motors also benefit from using third harmonic of this setting, Sin(12x) which may be enabled by setting it as TRF2 and doing same procedure for finding the optimum TRA2 value. | # Some motors also benefit from using third harmonic of this setting, Sin(12x) which may be enabled by setting it as TRF2 and doing same procedure for finding the optimum TRA2 value. | ||
'''Note:''' some motors do not receive significant benefit of these settings. In such case, it's recommended to leave these settings disabled (TRF1 & TRF2 = None and TRA1 & TRA2 = 0) to avoid making the smoothness actually worse. | '''Note:''' some motors do not receive significant benefit of these settings. In such case, it's recommended to leave these settings disabled (TRF1 & TRF2 = None and TRA1 & TRA2 = 0) to avoid making the smoothness actually worse. | ||
− | |||
− |