Editing Setting device bus address
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 96: | Line 96: | ||
Methods to eliminate the stub on [[SimpleMotion V2 port]] cable E-stop cable if longer than 30cm E-stop cable is needed: | Methods to eliminate the stub on [[SimpleMotion V2 port]] cable E-stop cable if longer than 30cm E-stop cable is needed: | ||
− | *Cut the | + | *Cut the A and B wires from the cable near connector, this ends the RS485 bus next to connector and minimizes stub |
− | *Alternatively, connect termination resistor at end of | + | *Alternatively, connect termination resistor at end of A and B pair and set DIP switch termination off |
==Troubleshooting== | ==Troubleshooting== | ||
Line 106: | Line 106: | ||
{{next|[[Argon user guide/Wiring]]}} | {{next|[[Argon user guide/Wiring]]}} | ||
− | |||
− | |||
− | |||
− |