Editing Argon EXT connector
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 16: | Line 16: | ||
*Output A,B,Z 3.3 volt signals | *Output A,B,Z 3.3 volt signals | ||
*Minimum output pulse length 2 µs (requirement for receiving device to accept count rate of 1 MHz) | *Minimum output pulse length 2 µs (requirement for receiving device to accept count rate of 1 MHz) | ||
− | *Output resolution is '''divided by 4''' compared to the native resolution of the feedback device | + | *Output resolution is '''divided by 4''' compared to the native resolution of the feedback device |
;Limitations | ;Limitations | ||
Line 45: | Line 45: | ||
In addition to this, pull-up resistors may be necessary in optoisolator outputs: three 470 to 1000 ohm resistors from A-ISOLATED to 5V-ISOLATED, B-ISOLATED to 5V-ISOLATED and Z-ISOLATED to 5V-ISOLATED. The need of pull-ups depend on whether the motion controller has internal pull-up resistors or not. | In addition to this, pull-up resistors may be necessary in optoisolator outputs: three 470 to 1000 ohm resistors from A-ISOLATED to 5V-ISOLATED, B-ISOLATED to 5V-ISOLATED and Z-ISOLATED to 5V-ISOLATED. The need of pull-ups depend on whether the motion controller has internal pull-up resistors or not. | ||
− | |||
− |