Editing Configuring IONI drive in SimuCUBE
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 74: | Line 74: | ||
|Fault limits | |Fault limits | ||
|{{Param|FOC}} | |{{Param|FOC}} | ||
− | | High | + | | High |
− | |Change this | + | |Change this only if over current fault problems occur with the motor |
|- | |- | ||
|Machine | |Machine | ||
Line 167: | Line 167: | ||
After SimuCUBE all settings have been configured and verified to work, you might want to become back to the settings and adjust motor current limits (MMC and MCC) to increase or adjust maximum torque of motor. | After SimuCUBE all settings have been configured and verified to work, you might want to become back to the settings and adjust motor current limits (MMC and MCC) to increase or adjust maximum torque of motor. | ||
{{next|[[Configuring MMos for SimuCUBE]]}} | {{next|[[Configuring MMos for SimuCUBE]]}} | ||
− | |||
− |