Editing Configuring VSD-E/XE for velocity mode
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 12: | Line 12: | ||
Useful [[GDtool]] settings: | Useful [[GDtool]] settings: | ||
*Choose None/Indexer as input source during tuning (so no drifting occurs during tuning). | *Choose None/Indexer as input source during tuning (so no drifting occurs during tuning). | ||
− | *Check that you have chosen correct encoder resolution and Trajectory planner settings have realistic | + | *Check that you have chosen correct encoder resolution and Trajectory planner settings have realistic veloicty limit setting. I.e. if you set limit to 2000 rpm, then +10V input will turn motor 2000 rpm and -10V turns 2000r pm in another direction. |
*Check that Trajectory planner multiplier and divider settings have equal values (i.e. 50:50) to get behavior described above | *Check that Trajectory planner multiplier and divider settings have equal values (i.e. 50:50) to get behavior described above | ||
*If motor has limited travel and axis reaches end of travel during tuning, just use negative value in "Step response amplitude" spinbox to reverse direction. | *If motor has limited travel and axis reaches end of travel during tuning, just use negative value in "Step response amplitude" spinbox to reverse direction. | ||
− | ===Adjusting offset in | + | ===Adjusting offset in analog input mode=== |
''PWM/Analog offset'' parameter helps to zero the offset & drifting present in PWM and analog input reference modes. | ''PWM/Analog offset'' parameter helps to zero the offset & drifting present in PWM and analog input reference modes. | ||
In GDtool 2.5.1 there is a bug that prevents adjusting "PWM/Analog offset" spinbox whenever analog has been selected from drop down box. To workaround this, temporarily choose PWM from drop box and adjust the offset value. After value changed, switch back to "Analog in" mode. Press ''Set'' after offset value is changed and mode is set back to Analog in (no need to press during adjustment). | In GDtool 2.5.1 there is a bug that prevents adjusting "PWM/Analog offset" spinbox whenever analog has been selected from drop down box. To workaround this, temporarily choose PWM from drop box and adjust the offset value. After value changed, switch back to "Analog in" mode. Press ''Set'' after offset value is changed and mode is set back to Analog in (no need to press during adjustment). | ||
− | |||
− |