Editing IONI connector pinout
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 187: | Line 187: | ||
==Electrical ratings== | ==Electrical ratings== | ||
− | [[File:Ioni io interlal circuits doc.png|thumbnail|right|IONI's internal circuity | + | [[File:Ioni io interlal circuits doc.png|thumbnail|right|IONI's internal circuity in feedback device port pins (the pins on D-15 connector on [[IONICUBE]]s)]] |
{| class="wikitable" | {| class="wikitable" | ||
! Signal names!!Allowed input voltages/output voltage!!Internal input/output impedance (Ω)!!Internal pull impedance (Ω) | ! Signal names!!Allowed input voltages/output voltage!!Internal input/output impedance (Ω)!!Internal pull impedance (Ω) | ||
Line 266: | Line 266: | ||
#Adjust SMO parameter value so that device will receive a desired bus address. I.e. if using IONICUBE 1X, set SMO values 0, 1, 2, 3 to the different drives (drive addresses will become 1, 2, 3, 4). Or when IONICUBE (4 axis) is being used, set SMO values of drives on the first board 0, second board 4, third 8 etc (drive addresses will become 1 - 12). | #Adjust SMO parameter value so that device will receive a desired bus address. I.e. if using IONICUBE 1X, set SMO values 0, 1, 2, 3 to the different drives (drive addresses will become 1, 2, 3, 4). Or when IONICUBE (4 axis) is being used, set SMO values of drives on the first board 0, second board 4, third 8 etc (drive addresses will become 1 - 12). | ||
#Save settings, disconnect and repeat the procedure for all drives. | #Save settings, disconnect and repeat the procedure for all drives. | ||
− | |||
− | |||
− |