Editing Motor compatibility guide
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | This page guides through matching the Granite Devices drive and various kinds of servo and stepping motors | + | This page guides through matching the Granite Devices drive and various kinds of servo and stepping motors. |
==Overview== | ==Overview== | ||
{{picturebox|drive_selection_by_motor.png|700px|caption=Refer to notes A-D below the image}} | {{picturebox|drive_selection_by_motor.png|700px|caption=Refer to notes A-D below the image}} | ||
Line 55: | Line 55: | ||
==Note D (stepping motor feedback)== | ==Note D (stepping motor feedback)== | ||
Stepping are used traditionally without any feedback devices (in open loop mode) or with feedback device (position sensor) to run in closed loop mode. For explanation of different possible modes, see [[Using stepping motor with IONI]]. | Stepping are used traditionally without any feedback devices (in open loop mode) or with feedback device (position sensor) to run in closed loop mode. For explanation of different possible modes, see [[Using stepping motor with IONI]]. | ||
− | |||
− | |||
− | |||
− | |||
− |