Editing SimuCUBE troubleshooting
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 26: | Line 26: | ||
Should the resistor measure more than 5 Ohm, and/or the MOSFET measures less than 10 kOhm, then double check your measurement, and if the results persist, then the respective component need to be changed. | Should the resistor measure more than 5 Ohm, and/or the MOSFET measures less than 10 kOhm, then double check your measurement, and if the results persist, then the respective component need to be changed. | ||
− | [[File:Simucube regen. resistor cirquit measurement.jpg|none|thumb|SimuCUBE | + | [[File:Simucube regen. resistor cirquit measurement.jpg|none|thumb|SimuCUBE regenerative resistor circuit measurement pads.]] |
=== SimuCUBE won't go into DFU mode === | === SimuCUBE won't go into DFU mode === | ||
Line 36: | Line 36: | ||
It is possible, but very rare, that SimuCUBE gets stuck in DFU mode or switches to DFU mode by itself without user interaction. | It is possible, but very rare, that SimuCUBE gets stuck in DFU mode or switches to DFU mode by itself without user interaction. | ||
Please refer to separate support article: [[SimuCUBE stuck in DFU mode]] | Please refer to separate support article: [[SimuCUBE stuck in DFU mode]] | ||
− | |||
− | |||
− |