Difference between revisions of "Setpoint signal"
From Granite Devices Knowledge Wiki
[quality revision] | [checked revision] |
Line 53: | Line 53: | ||
|} | |} | ||
[[Category:Signals]] | [[Category:Signals]] | ||
+ | [[Category:Glossary]] |
Revision as of 16:13, 24 March 2013
Reference signal is a signal that will be used as target value in control systems. Typical occurrencies of reference signals in GD products are:
- Position reference
- Velocity reference
- Torque reference
I.e. position reference value may be "1234" which could mean a target position of 1234 mm in some linear actuator. Or torque reference of 5.0 could mean that motor is asked to produce 5 Nm torque.
Physical reference signal types
Reference signals may have several representations in real world such as:
- Analog reference signal
- Pulse and direction signals
- PWM signal
- Serial communication command
In these cases there will be a conversion between input and output units. For example when using +/-10V reference as velocity reference, the relation betveen input to output types could be 1 Volt per 100 rpm (or any other scale).
Reference signal characteristics
Analog | Pulse & dir or Quadrature | PWM | Network | |
---|---|---|---|---|
Scale & range | Absolute (limited) | Incremental (infinite) | Absolute (limited) |
|
Reference uses in motion control | Torque, velocity | Position, velocity | Torque, velocity | Position, torque, velocity |
Pros |
|
|
|
|
Cons |
|
|
|
|