Difference between revisions of "Granity user guide/Tuning"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(→Velocity controller gains) |
(→Parameters) |
||
| Line 37: | Line 37: | ||
! Short [[GUI]] name !! [[GUI]] name !! Description !! How to use | ! Short [[GUI]] name !! [[GUI]] name !! Description !! How to use | ||
|- | |- | ||
| − | | KPP || | + | | KPP || Position P gain || The proportional gain of position controller || See [[Servo motor tuning guide]]. |
|- | |- | ||
| − | | AD || | + | | AD || Anti-dither || Motor dithering/zero error hunting reduction function (in current firmware: no effect) || Useful in future firmware |
|} | |} | ||
[[Category:Granity user guide]] | [[Category:Granity user guide]] | ||
Revision as of 21:10, 14 August 2013
Tuning tab serves following purposes:
- Adjust torque control bandwidth
- Tune velocity controller gains
- Tune position controller gains
Parameters
Torque controller
| Short GUI name | GUI name | Description | How to use |
|---|---|---|---|
| TBW | Torque bandwidth limit | Sets the low pass filter frequency for torque controller setpoint signal | Limiting torque bandwidth to a certain level may have several advantages:
Try various values to find the optimum for your system. Typically higher value allows setting higher velocity and position P gains giving more servo stiffness. Typically the optimum bandwidths are between 220-1500 Hz. If you wish to check torque controller step response in testing tab, then before testing set this value to maximum and also untick Goals/CIS. |
Velocity controller gains
| Short GUI name | GUI name | Description | How to use |
|---|---|---|---|
| KVP | Velocity P gain | The proportional gain of velocity controller | See Servo motor tuning guide. |
| KVI | Velocity I gain | The integral gain of velocity controller | |
| VFF | Velocity feed-forward gain | Velocity feed-forward gain | |
| AFF | Acceleration feed-forward gain | Acceleration feed-forward gain |
Position controller gains
| Short GUI name | GUI name | Description | How to use |
|---|---|---|---|
| KPP | Position P gain | The proportional gain of position controller | See Servo motor tuning guide. |
| AD | Anti-dither | Motor dithering/zero error hunting reduction function (in current firmware: no effect) | Useful in future firmware |
