Difference between revisions of "Granity user guide/Testing"

Revision as of 17:53, 17 August 2013

This tab serves following purposes:

• Running repeating test sequence on motor
• Capturing reference signal & feedback graphs from drive

Test stimulus generator

Test stimulus as numeric parameters and it's graphical representation

Test stimulus generator is a way to feed a repeating setpoint signal to the drive without having any other physical signals supplied. Test stimulus generates a square waveform with user specified amplitudes and timing.

The waveform generated is specified by 4 parameters:

Short GUI name	GUI name	Description	How to use
TSP1	Target setpoint 1	The first setpoint level	Adjust the value and observe the right side value conversion to the real world units such as amperes or millimeters.
TSD1	Delay 1	The active duration of the first setpoint	Set the duration of the first setpoint lenght.
TSP2	Target setpoint 2	The second setpoint level	Adjust the value and observe the right side value conversion to the real world units such as amperes or millimeters.
TSD2	Delay 2	The active duration of the second setpoint	Set the duration of the second setpoint length.
TSE	Enable test stimulues	Control test stimulus feed	Tick this checkbox to instantly start feeding test stimulus to the drive. Before ticking ensure that setpoints are set to safe levels and always be prepared stop motor safely if unexpected motion happens.
Example where TSD1=0.1s TSD2=0.5s TSP1=1000→0.18A TSP2=-500→-0.09A

Capture & graphs

Capture controls

Capture signals selection

Device state

Devices state updates continuously while connected and shows status & fault register bits as well as state of physical I/O lines and setpoint value.

Troubleshooting