Difference between revisions of "Splitting encoder signal"
| [checked revision] | [checked revision] |
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Some times it is necessary to feed encoder signal of motor to two devices: to drive and the motion controller (such as Mesa card in LinuxCNC installation). In such case, the safest way is to use optoisolators to provide second encoder output that is galvanically isolated from the original signal. | Some times it is necessary to feed encoder signal of motor to two devices: to drive and the motion controller (such as Mesa card in LinuxCNC installation). In such case, the safest way is to use optoisolators to provide second encoder output that is galvanically isolated from the original signal. | ||
| − | {{picturebox|Encodersplitter.png|caption=Splitting encoder signals with isolation. 5V-ISOLATED should be connected to motion controller's 5V supply (powering the optoisolators).}} | + | {{picturebox|Encodersplitter.png|caption=Splitting encoder signals with isolation. 5V-ISOLATED should be connected to motion controller's 5V supply (powering the optoisolators). Note: if long cables used (>3m), then termination of encoder differential pairs (A+ to A- etc) may be necessary with 120 ohm resistors at the drive/controller end.}} |
| + | |||
| + | Suggested part types for isolation are: | ||
| + | *Optoisolators: H11L1 (support frequency up to 500 kHz) | ||
| + | *Resistors: 1 kOhm | ||
| + | *Capacitor (for opto 5V supply): 100nF 25V ceramic. Optionally also 10-100uF electrolytic in parallel. | ||
| + | |||
| + | {{picturebox|Encodersplitternoniso.png|caption=Splitting encoder signals without isolation. Note: if long cables used (>3m), then termination of encoder differential pairs (A+ to A- etc) may be necessary with 120 ohm resistors at the drive/controller end.}} | ||
[[category:Setup guides]] | [[category:Setup guides]] | ||
[[category:Argon user guide]] | [[category:Argon user guide]] | ||
| − | [[category: | + | [[category:IONI user guide]] |
Latest revision as of 11:27, 12 May 2015
Some times it is necessary to feed encoder signal of motor to two devices: to drive and the motion controller (such as Mesa card in LinuxCNC installation). In such case, the safest way is to use optoisolators to provide second encoder output that is galvanically isolated from the original signal.
Splitting encoder signals with isolation. 5V-ISOLATED should be connected to motion controller's 5V supply (powering the optoisolators). Note: if long cables used (>3m), then termination of encoder differential pairs (A+ to A- etc) may be necessary with 120 ohm resistors at the drive/controller end.
Suggested part types for isolation are:
- Optoisolators: H11L1 (support frequency up to 500 kHz)
- Resistors: 1 kOhm
- Capacitor (for opto 5V supply): 100nF 25V ceramic. Optionally also 10-100uF electrolytic in parallel.
Splitting encoder signals without isolation. Note: if long cables used (>3m), then termination of encoder differential pairs (A+ to A- etc) may be necessary with 120 ohm resistors at the drive/controller end.
