Difference between revisions of "SimpleMotion V2 compatible communication interface device"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(→List of tested devices) |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 9: | Line 9: | ||
===Known good devices=== | ===Known good devices=== | ||
*[[SimpleMotion V2 USB adapter]] | *[[SimpleMotion V2 USB adapter]] | ||
| + | *[[DIY SimpleMotion V2 adapter]] | ||
| + | *[http://www.ftdichip.com/ FTDI] USB UART based RS485 adapters | ||
| + | |||
===Known incompatible devices=== | ===Known incompatible devices=== | ||
None yet | None yet | ||
[[Category:SimpleMotion]] | [[Category:SimpleMotion]] | ||
Latest revision as of 11:03, 17 September 2015
This page lists known good interface devices for SimpleMotion V2 bus.
Contents
Compatibility in theory[edit | edit source]
To communicate with SimpleMotion V2 bus, a RS485 serial port is needed. The requirements are:
- 460800 PBS bitrate support
- 8 data bits + 1 data bit
- Half duplex RS485 with 3 wires: ground, A, B
- Visible as serial port on a PC (COM port in Windows, /dev/ttyNNN in Unix)
List of tested devices[edit | edit source]
Known good devices[edit | edit source]
- SimpleMotion V2 USB adapter
- DIY SimpleMotion V2 adapter
- FTDI USB UART based RS485 adapters
Known incompatible devices[edit | edit source]
None yet
