Difference between revisions of "Setpoint signal"
From Granite Devices Knowledge Wiki
| [unchecked revision] | [unchecked revision] |
(→Physical reference signal types) |
(→Physical reference signal types) |
||
| Line 6: | Line 6: | ||
==Physical reference signal types== | ==Physical reference signal types== | ||
Reference signals may have several representations in real world including: | Reference signals may have several representations in real world including: | ||
| − | * Analog | + | * [[Analog reference]] signal |
* [[Pulse and direction]] signals | * [[Pulse and direction]] signals | ||
* [[PWM]] signal | * [[PWM]] signal | ||
Revision as of 14:32, 26 March 2012
Reference signal is a signal that will be used as target value in control systems. Typical occurrences of reference signals in GD products are:
- Position reference
- Veloicty reference
- Torque reference
I.e. position reference value may be "1234" which could mean a target position of 1234 mm in some linear actuator. Or torque reference of 5 Nm would mean that motor is asked to produce 5 Nm torque.
Physical reference signal types
Reference signals may have several representations in real world including:
- Analog reference signal
- Pulse and direction signals
- PWM signal
- Serial communication command
In these cases there will be a conversion between input and output units. For example when using +/-10V reference as velocity reference, the relation betveen types could be 1 Volt per 100 rpm (or any other scale).
