DIY SimpleMotion V2 adapter
It is possible to build SimpleMotion V2 compatible communication interface device from commonly available parts. This article gives instructions of making one from the parts listed below.
- 1pcs FTDI's USB to RS485 adapter cable, USB-RS485-WE-1800-BT
- 1pcs Non-cross linked RJ45 cable (cable will be cut, so one cable is good up to two adapters)
- 2pcs 620 to 680 ohm leaded resistors
- 1pcs 6 pole terminal block
- 1pcs cable tie
Assembly guide
Needed parts (sold as kit)
Needed tools
Stripping insulation of RJ45 cable
Stripping individual wires of RJ45 cable. Shorten out all except green/white, green and brown.
Making connections with terminal block
Securing with cable tie
Final product
In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.
As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.
Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.
