Testing of drive IO pins

From Granite Devices Knowledge Wiki
Revision as of 13:49, 2 October 2015 by Tero K (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to: navigation, search
Jumper wires that are useful in this testing method
In cases a signal is not correctly getting through to drive (such as direction signal in step/dir mode), there is a way to test if the problem lies within the drive or exernal circuity. This page describes by example how to test Direction input of drive.

Procedure for differential inputs[edit | edit source]

Step 1. Disconnect any cable from I/O connector and use jumper wires to connect the GND and 5V to pins under test. In this case we test HSIN2 by following wiring:

TestingHSIN2.png

Step 2. Connect to drive with Granity software and inspect status of the HSIN2 from Testing page status information.

Step 3. Analyze. If all worked correctly, pin state should have changed in Granity. If pin state is stuck, check connections. If still no luck, it is possible that input pin of device has been damaged. If signal state changes as expected, then the error is not in the drive, but probably in the wiring or source of the signal.

This method works also for analog inputs. Instead, just check analog readings of inputs from Granity. You should see +5V or -5V in this test.
For single ended input (ones found in IONI for example), just connect the input with single wire to either 5V or GND.

In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.

Retrieved from "https://granitedevices.com/w/index.php?title=Testing_of_drive_IO_pins&oldid=4602"