IONI power supply schemes

Scheme	Description	Pros	Cons
	Two switching power supplies, one high power voltage supply for motor and one low power supply for logic circuity. A diode D1 is necessary to protect regenerative current flow going back to PSU1. For recommended diodes, see paragraph below.	Fault tolerant Compact Availability of parts	High power PSU cost when above 200W Switching PSUs typically don't allow temporary overloading
	Two similar high power supplies are used to supply both motor and logic voltages. In this system power of PSU1 and PSU2 will contribute to motor supply, i.e. if both supplies are rated 200W, then total power available to drives is ~400W. Diodes D1 is needed to protect power supplies from regenerative power and D2/D3 to protect power supplies in the case where one power supply would shut down (i.e. on overload). For recommended diodes, see the paragraph below.	Cost saving (i.e. 2x200W 24V is lower cost than 1x400W 48V) Compact Availability of parts	In PSU fault/overload, drive logic power may be instabilized Switching PSUs typically don't allow temporary overloading
	Linear (transformer based unregulated) power supply is used for motor supply and low power switching PSU for logic power.	No need for diodes Linear PSU peak power handling	Size & weight Lower availability of linear power supplies Fluctiation of AC mains voltage may trigger overvoltage fault on drives if PSU voltage is normally near drive's maximum

Diodes D1-D3 are typical silicon or schottky rectifier diodes that are sufficiently rated to carry the present voltages and currents. As diodes are inexpensive, there is no need to avoid oversizing them. Examples diodes:

• Diodes Inc. 10A02-T (10A 100V, leaded)
• Diodes Inc. 10A04-T (10A 400V, leaded)
• Fairchild FFPF30UP20STU (30A, 200V, leaded, isolated TO-220 case)
• Fairchild RURG3060 (30A 600V, leaded, non-isolated case - cooling tab is either anode or cathode)
• Fairchild STPS20120D (20A 120V, leaded, non-isolated case - cooling tab is either anode or cathode)

In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.