Template:DriveStatusbits

Name	Description	Troubleshooting
Initialized	True when drive has completed initialization procedure (such as phasing)	If never goes on, check parameters, drive input voltage, safe torque off and enable inputs and possible faults.
Error recovering	True when drive performs position return to the setpoint position after clear faults command is given
Tracking error warn	Indicates that tracking error has increased beyond certain point. On most drives this controls a digital output pin that may be used in conjunction with controller to mitigate a tracking error problem before a tracking error fault is triggered. Operation depends on operating mode: Position mode: true when position tracking error is greater than 1/8 of Position tracking error thresholdFPT Velocity mode: true when velocity tracking error is greater than 1/8 of Velocity tracking error thresholdFVT Torque mode: true when actual torque differs from torque setpoint more than 1/4 of Peak current limitMMC. This is not present in GraniteCore G2.0 devices (ARGON), and on that drive it will always read false.
Target reached	True when drive's internal motion profiler (velocity & acceleration limited motion) has reached the user setpoint value and other conditions are met. Full list of conditions of this status being true are: Trajectory planner output is stationary (for more info, see signal path of motor drive) Following status bits are false: Follow error recovery Homing Fault stop Follow error warning And following status bits are true: Initialized Enabled Run (drive active)
Enabled	True when drive has enabled state on. This allows drive to control motor if no faults are active.
Run (drive active)	True when drive is initializing or controlling motor. Goes false if enabled is false or faults are active
Homing active	True when drive is performing homing sequence. Goes false after homing is complete or not enabled
Braking	True when motor is being braked electrically and/or mechanically
Permanent stop	True when drive requires restart before continuing motor control. Goes true when changing certain parameters or if initialization fails	Restart drive to see if the state clears. If not, check parameterization and usage errors.
Voltages good	True when HV DC bus voltage is withing configured range (from Under voltage fault thresholdFUV to Over voltage fault thresholdFOV)
Fault stopped	True when drive is disabled true to active fault state	Perform clear drive faults function (from Connect tab). If problem repeats, check motor & tuning parameters and operating conditions. See fault register and fault location for hints.
Ready for use	True when drive has performed all initializations, possible homing and is enabled and running. When true, drive is ready to follow user setpoint commands
STO active	True when safe torque off is active. In Argon this monitors only STO2.