Editing Argon resolver adapter
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | [[File:Argonresolveradapter.jpg|thumb | + | [[File:Argonresolveradapter.jpg|thumb|Argon resolver adapters. These plug into Argon J1 port and resolver wires are directly connected to the pads of adapter.]] |
− | Argon resolver adapter is a small sized device that adds [[Feedback devices|resolver]] feedback device support to [[Argon]] servo drive. | + | Argon resolver adapter is a small sized adapter device that adds [[Feedback devices|resolver]] feedback device support to [[Argon]] servo drive. |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
==Usage== | ==Usage== | ||
− | |||
[[File:Resolveradapterwiring.png|thumb|320px|Connection of resolver to adapter.]] | [[File:Resolveradapterwiring.png|thumb|320px|Connection of resolver to adapter.]] | ||
− | Resolver has total of 6 wires and 3 windings: one for rotor (primary) and two stators (secondaries). Rotor connects to the adapter pins A+ and A- while secondaries connect to B+/- and C+/-. | + | Resolver has total of 6 wires and 3 windings: one for rotor (primary) and two stators (secondaries). Rotor connects to the adapter pins A+ and A- while secondaries connect to B+/- and C+/-. A shielded cable is required and shield should be connected to D-sub connector frame to reduce [[EMI]] noise. |
If pin-out of resolver is unknown, it can be found out with multimeter by finding the wire pairs where coils are connected. Rotor can be identified by searching for lowest resistance coil. Stators typically have at least twice as high resistance compared to rotor. | If pin-out of resolver is unknown, it can be found out with multimeter by finding the wire pairs where coils are connected. Rotor can be identified by searching for lowest resistance coil. Stators typically have at least twice as high resistance compared to rotor. | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− |