Difference between revisions of "Argon user guide/J5 connector electrical interfacing"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
| Line 5: | Line 5: | ||
;Supply ratings | ;Supply ratings | ||
| − | *Output voltage 4.9-5. | + | *Output voltage 4.9-5.2 V |
| − | *Maximum | + | *Maximum load 500 mA |
| − | + | *Maximum injected current -10 mA | |
{{Caution|Never connect multiple supply outputs parallel. Supply output may be connected only current consuming circuity to prevent current injection to the supply port.}} | {{Caution|Never connect multiple supply outputs parallel. Supply output may be connected only current consuming circuity to prevent current injection to the supply port.}} | ||
===High speed digital input=== | ===High speed digital input=== | ||
| Line 30: | Line 30: | ||
===Digital input=== | ===Digital input=== | ||
[[Category:Argon setup guide]] | [[Category:Argon setup guide]] | ||
| + | [[Category:Unfinished]] | ||
Revision as of 22:18, 13 June 2013
This article explains the internal circuity behind J5 connector of Argon servo drive.
Contents
Pin electrical categories=
Supply
Supply pins output a regulated 5V voltage to external circuits. GND pin is tied to J3 connector V- terminal.
- Supply ratings
- Output voltage 4.9-5.2 V
- Maximum load 500 mA
- Maximum injected current -10 mA
 | Never connect multiple supply outputs parallel. Supply output may be connected only current consuming circuity to prevent current injection to the supply port. |
High speed digital input
HSIN is differential digital input capable of receiving digital signals up to 4 MHz.
- Input ratings
- Maximum voltage to +/- pins referenced to GND: -0.5 to 6V. Nominal 3.3 or 5.0V.
- Maximum injected current +/- 10 mA
- Wiring when driving using differential source
- Positive (+) inputs: to positive outputs of source
- Negative (-) inputs: to negative outputs of source
- GND must be connected to source ground
- Wiring when driving using single ended source (TTL, CMOS or open collector)
- Positive (+) inputs: to positive outputs of source
- Negative (-) inputs: leave floating
- GND must be connected to source ground
