Difference between revisions of "Argon user guide/J5 connector electrical interfacing"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
(High speed digital input)
Line 21: Line 21:
 
*Maximum injected current +/- 10 mA
 
*Maximum injected current +/- 10 mA
 
*When negative input (-) is left floating, it floats around 2.5V
 
*When negative input (-) is left floating, it floats around 2.5V
*Input state reads 1 when voltage at positive pin is greater than voltage of negative pin, otherwise it reads 0
+
*Input state reads 1 when voltage on positive pin is greater than voltage on negative pin, otherwise it reads 0
  
 
;Wiring when driving using differential source
 
;Wiring when driving using differential source

Revision as of 17:10, 14 June 2013

This article explains the internal circuity behind J5 connector of Argon servo drive.


Pin electrical categories

Supply

Supply pins output a regulated 5V voltage to external circuits. GND pin is tied to J3 connector V- terminal.

Electrical properties
  • Output voltage 4.9-5.2 V
  • Maximum load 500 mA
  • Maximum injected current -10 mA

High speed digital input

The HSIN circuity inside the drive. Left side end represents J5 pins and right side continues to drive internal circuity.

HSIN is differential digital input capable of receiving digital signals up to 4 MHz.

Electrical properties
  • Maximum voltage to +/- pins referenced to GND: -0.5 to 6V. Nominal 3.3 or 5.0V.
  • Maximum injected current +/- 10 mA
  • When negative input (-) is left floating, it floats around 2.5V
  • Input state reads 1 when voltage on positive pin is greater than voltage on negative pin, otherwise it reads 0
Wiring when driving using differential source
  • Positive (+) inputs: to positive outputs of source
  • Negative (-) inputs: to negative outputs of source
  • GND must be connected to source ground
Wiring when driving using single ended source (TTL, CMOS or open collector)
  • Positive (+) inputs: to outputs of source
  • Negative (-) inputs: leave floating
  • GND must be connected to source ground

Analog input

Digital output

Digital input