Editing Argon user guide/LED indicators
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | + | Argon has four front panel led indicators which have dedicated indicating tasks: | |
*LD1 SimpleMotion transmit led. Blinks when drive transmits data to bus. | *LD1 SimpleMotion transmit led. Blinks when drive transmits data to bus. | ||
*LD2 SimpleMotion receive led. Blinks when drive receives data from bus. | *LD2 SimpleMotion receive led. Blinks when drive receives data from bus. | ||
Line 10: | Line 10: | ||
*LD3 and shows the first fault occurred if multiple fault states are active simultaneously. | *LD3 and shows the first fault occurred if multiple fault states are active simultaneously. | ||
==List of all LD3 and LD4 sequences== | ==List of all LD3 and LD4 sequences== | ||
− | To see | + | To see animations, make sure web browser animations are enabled. |
===Faults originated from I/O side of drive=== | ===Faults originated from I/O side of drive=== | ||
Only LD3 is being controlled by these faults. | Only LD3 is being controlled by these faults. | ||
− | |||
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
Line 59: | Line 58: | ||
| Setpoint range exceeded || [[File:3LSSL.gif]] || LSSL | | Setpoint range exceeded || [[File:3LSSL.gif]] || LSSL | ||
|- | |- | ||
− | | Other/unknown | + | | Other/unknown || [[File:3SSSL.gif]] || SSSL |
|} | |} | ||
Line 79: | Line 78: | ||
|- | |- | ||
| Run || [[File:4ON.gif]] || On ||yes | | Run || [[File:4ON.gif]] || On ||yes | ||
− | |||
− | |||
|} | |} | ||
− | |||
− | |||
− |