Difference between revisions of "Estimating power need of motor drive system"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
(Created page with "Estimating the need of power supply wattage for motor drive can be a complex task. The needed power depends on the actual mechanical load and use of motor. The power demand is...")
 
Line 2: Line 2:
  
 
<math>Power=Speed*Torque</math>{{mathtip}}
 
<math>Power=Speed*Torque</math>{{mathtip}}
+
 
 +
Instantenous power output of motor can be estimated from the equation:
 +
 
 +
<math>P_mechanical [kW] = frac{Torque [Nm] * Speed [RPM]}{9.5488} </math>
 +
 
 +
As that is the ''output'' mechanical power of motor, the input electrical power should be estimated by:
 +
 
 +
<math>P_electrical [kW] = frac{P_mechanical}{0.01*Efficiency [%]}</math>
 +
 
 
{| class="wikitable"
 
{| class="wikitable"
 
|-
 
|-

Revision as of 15:08, 3 December 2015

Estimating the need of power supply wattage for motor drive can be a complex task. The needed power depends on the actual mechanical load and use of motor. The power demand is proportional to the product of motor speed and torque:

$ Power=Speed*Torque $ click to enlarge equations

Instantenous power output of motor can be estimated from the equation:

$ P_mechanical [kW] = frac{Torque [Nm] * Speed [RPM]}{9.5488} $

As that is the output mechanical power of motor, the input electrical power should be estimated by:

$ P_electrical [kW] = frac{P_mechanical}{0.01*Efficiency [%]} $

Moving slowly Moving fast
Producing low torque Very low power consumption Low to medium power consumption
Producing high torque Low to medium power consumption High power consumption

In overall, PSU should be sized so that it does not overload or overheat during any condition in machine use. Since servo systems typically have greatly varying load, it might be necessary to find effective power consumption by measuring RMS power consumption of the system during at least 10 second period of heavy use.

If measurements can't be done, then maximum RMS power load can be estimated roughly by summing rated power values of motors in the system. However, in typical machines the average power consumption is significantly less than summed motor power. Motor power consumption is proportional to product of actual torque and speed (Power=Speed*Torque). Following chart gives rough figure of power requirement in motion systems: