Editing Granity user guide/Connect
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 31: | Line 31: | ||
# Wire up IONICUBE logic power (24V) supply. | # Wire up IONICUBE logic power (24V) supply. | ||
# Connect IONICUBE connector X1 (any of two ports) connector to [[SimpleMotion V2 USB adapter]] with a straight Ethernet cable and plug USB adapter to computer. | # Connect IONICUBE connector X1 (any of two ports) connector to [[SimpleMotion V2 USB adapter]] with a straight Ethernet cable and plug USB adapter to computer. | ||
− | #Make sure that SM bus termination is set on | + | #Make sure that SM bus termination is set on (IONICUBE 4 axis board: insert jumper to JP10 position 1, see image [[IONI & IONICUBE user guide/Making the first Granity connection|here]]) and IONICUBE 1X, set DIP switch S1 position 1 on). |
− | + | ||
− | + | ||
− | + | ||
# Power up the 24 VDC power. Some leds should start blinking at the drive. | # Power up the 24 VDC power. Some leds should start blinking at the drive. | ||
# Launch Granity software and: | # Launch Granity software and: | ||
Line 105: | Line 102: | ||
*See [[Device connection troubleshooting]] | *See [[Device connection troubleshooting]] | ||
{{next|[[Granity user guide/Goals]]}} | {{next|[[Granity user guide/Goals]]}} | ||
− | |||
− |