Difference between revisions of "Granity user guide/Tuning"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
m (Text replacement - "{{param|GUI}}" to "GUI")
Line 48: Line 48:
 
| AD || Anti-dither || Motor dithering/zero error hunting reduction function (in current firmware: no effect) || Useful in future firmware
 
| AD || Anti-dither || Motor dithering/zero error hunting reduction function (in current firmware: no effect) || Useful in future firmware
 
|}
 
|}
 +
 +
===Torque cogging & ripple compensation===
 +
{| class="wikitable"
 +
|-
 +
! Short [[GUI]] name !! [[GUI]] name !! Description !! How to use
 +
|-
 +
| TRF1 || Cogging compensation function || Selects the function of compensator  || rowspan=4| See [[Configuring cogging torque compensation]]
 +
|-
 +
| TRA1 || Cogging compensation current|| Adjusts the amplitude of summed compensating torque command
 +
|-
 +
| TRF2 || Torque ripple compensation function || Selects the function of compensator
 +
|-
 +
| TRA2 || Torque ripple compensation amplitude || Adjust the modulation depth of compensator 
 +
|-
 +
|}
 +
 
{{next|[[Granity user guide/Fault limits]]}}
 
{{next|[[Granity user guide/Fault limits]]}}
  
 
[[Category:Granity_user_guide]]
 
[[Category:Granity_user_guide]]

Revision as of 23:16, 2 November 2015

GranityTuning.png

Tuning tab serves following purposes:

  • Adjust torque control bandwidth
  • Tune velocity controller gains
  • Tune position controller gains

See also:

Parameters

Torque controller

Short GUI name GUI name Description How to use
TBW Torque bandwidth limit Sets the low pass filter frequency for torque controller setpoint signal Limiting torque bandwidth to a certain level may have several advantages:
  • Improve tuning of velocity or position mode
  • Reduce motor audible noise
  • Smoothen motion

Try various values to find the optimum for your system. Typically higher value allows setting higher velocity and position P gains giving more servo stiffness. Typically the optimum bandwidths are between 220-1500 Hz.

If you wish to check torque controller step response in testing tab, then before testing set this value to maximum and also untick Goals/CIS.

Velocity controller gains

Short GUI name GUI name Description How to use
KVP Velocity P gain The proportional gain of velocity controller See Servo motor tuning guide.
KVI Velocity I gain The integral gain of velocity controller
VFF Velocity feed-forward gain Velocity feed-forward gain
AFF Acceleration feed-forward gain Acceleration feed-forward gain

Position controller gains

Short GUI name GUI name Description How to use
KPP Position P gain The proportional gain of position controller See Servo motor tuning guide.
PFF Position feed-forward gain Sets feed foward gain from position setpoint to velocity setpoint Adjust to minimize position response overshooting.
AD Anti-dither Motor dithering/zero error hunting reduction function (in current firmware: no effect) Useful in future firmware

Torque cogging & ripple compensation

Short GUI name GUI name Description How to use
TRF1 Cogging compensation function Selects the function of compensator See Configuring cogging torque compensation
TRA1 Cogging compensation current Adjusts the amplitude of summed compensating torque command
TRF2 Torque ripple compensation function Selects the function of compensator
TRA2 Torque ripple compensation amplitude Adjust the modulation depth of compensator