Editing IONI & IONICUBE user guide/Making the first Granity connection

{{IoniManualNav}}{{parent|IONI & IONICUBE user guide}}Follow the instructions to make the first Granity connection to IONI drive.
==Preparations==
# Download and install the [[Granity]] software. Latest version can be downloaded from the link: [http://granitedevices.com/assets/files/granity_setup.exe Granity software] for windows (approx 18 MB)
# Make a wiring similar to the image below
#*With IONICUBE 4X revision 008 and lower, make sure that in the pinheader JP10 only position 1 has a jumper as depicted.
#*With IONICUBE 4X revision 009 and higher, make sure that the switch S1 position 1 is ON and position 4 (DFU mode) is OFF.
#*If you use a USB cable to connect (r. 009 and higher), turn also S1 position 2 and 3 ON.
# Connect IONICUBE to a PC
#* with [[SimpleMotion V2 USB adapter]] and a straight Ethernet cable to connector X1, or
#* with an USB cable without any adapters.
# Power up the 24 VDC power. Leds at the back of the IONI drive should start blinking ([[IONI & IONICUBE user guide/LED indicators|more about blinking sequences]]). 
# Launch Granity software and:
##Go to Connect tab
##Ensure that "SimpleMotion V2 Adapter" is selected from dropdown menu called ''Communication interface device''. (note 1)
##Click ''Connect to drive''
##Once list of connected drives pop up, select the one you connected and click ''Open''

Now if everything has gone well, you should see information about the drive model and serial number on the "Connect tab". Connection has been successfully tested and drive may be disconnected to proceed with next setup step.

Note 1) If multiple choices are named as "SimpleMotion V2 Adapter", then try each of them to find the correct one. Also if no adapters are found, try launching Granity software again as the list of adapter choices are updated only at program start-up.

{{picturebox|Ionicube granity minimum.png|caption=Minimum connection for Granity}}
{{picturebox|Ionicube_009_dip_switch_detail.png|caption=SM Bus termination switch position for IONICUBE revision 009 and higher.}}

More information about the termination and biasing of the RS485 serial bus here: [[Wikipedia:RS-485]].

{{next|[[IONI & IONICUBE user guide/Wiring overview]]}}