Editing Motor not moving troubleshooting
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 8: | Line 8: | ||
:Double check all motor parameters especially on Machine tab of Granity. Also see the previous paragraph ↑↑. | :Double check all motor parameters especially on Machine tab of Granity. Also see the previous paragraph ↑↑. | ||
;No setpoint signal | ;No setpoint signal | ||
− | :Try moving motor by giving commands Granity's Set Abs and Set Inc buttons | + | :Try moving motor by giving commands Granity's Set Abs and Set Inc buttons. |
;Output current is insufficient to overcome load friction or weight | ;Output current is insufficient to overcome load friction or weight | ||
:Try increasing motor current limits or try motor without any load | :Try increasing motor current limits or try motor without any load | ||
Line 21: | Line 21: | ||
*Motor pole count {{param|MPC}} - if unsure, see [[Determining motor pole count]] page | *Motor pole count {{param|MPC}} - if unsure, see [[Determining motor pole count]] page | ||
*Hall sensors not properly functioning - try {{param|FBH}} setting Off | *Hall sensors not properly functioning - try {{param|FBH}} setting Off | ||
− | |||
− | |||
− |