Editing PWM
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | + | PWM a.k.a. Pulse-width modulation is a voltage waveform usually seen in power electronics such as motor drives and power supplies. | |
− | PWM a.k.a. | + | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
+ | The main idea in PWM is to switch input voltage either fully on or off so rapidly that output device "feels" only the average voltage caused by pulsed voltage. | ||
+ | ==Pros and cons== | ||
+ | ===Pros=== | ||
+ | * Very high efficiency due to low losses in electronics | ||
+ | * Robust | ||
+ | * Usually very little heat sinking needed | ||
+ | ===Cons=== | ||
+ | * Increased [[Electromagnetic interference|EMI noise]] compared to linear (non-pulsed) output | ||
==Usage in GD products== | ==Usage in GD products== | ||
− | === | + | ===Motor output=== |
− | All GD motor drives produce PWM signal to motor. I.e. if drive supply voltage is 48VDC, then motor output pins will be driven either to 0V or 48V at switching rate of 15-20kHz | + | All GD motor drives produce PWM signal to motor. I.e. if drive supply voltage is 48VDC, then motor output pins will be driven either to 0V or 48V at switching rate of 15-20kHz. |
Inductance of motor coils will average the PWM pulses to equivalent DC. If motor inductance is very low, additional inductor is needed between drive and motor phases. | Inductance of motor coils will average the PWM pulses to equivalent DC. If motor inductance is very low, additional inductor is needed between drive and motor phases. | ||
− | + | ===As command signal=== | |
− | + | In some drive models, PWM signal can be used also as reference signal to replace analog signal (the +/- 10V control). In this case PWM voltage is typically 3-5V and the duty cycle of signal determines the amplitude. | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | ===As | + | |
− | In some drive models, PWM signal can be used also as | + | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
+ | Compared to analog input in VSD products 0% PWM duty cycle equals -10V, 50% equals 0V and 100% equals +10V. | ||
==Links== | ==Links== | ||
[http://en.wikipedia.org/wiki/Pulse-width_modulation Wikipedia PWM article] | [http://en.wikipedia.org/wiki/Pulse-width_modulation Wikipedia PWM article] | ||
− | |||
− | |||
− |