Editing Reading and writing an arbitrary parameter with Granity

It's possible to read and modify drive parameters that are not displayed in the [[GUI]] of [[Granity]]. This is done by a custom parameter dialog that pops up by Ctrl+P keyboard shortcut.
==Reading an arbitrary parameter==
[[File:readingarbparameter.png|thumb|An example of reading parameter with address 202 ({{param|KVP}})]]
#Open dialog by Ctrl+P keyboard shortcut
#Enter the desired parameter number to the ''Display custom parameter in status page'' spinbox. Note: if non-existing parameter is requested, a communication error will occur and Granity disconnects.
#Click Apply button on the main window
#Observe the value of parameter in the Testing tab
==Writing/overriding an arbitrary parameter==
[[File:Settingarbparameter.png|thumb|An example of reading AND writing parameter with address 202 ({{param|KVP}})]]
Before writing a custom parameter, it is advised to read it's current value first by the steps above. 

Writing a value:
#Open dialog by Ctrl+P keyboard shortcut
#Enter the desired parameter number and value to the ''Parameter override table''. Note: if non-existing parameter number is entered, a communication error will occur and Granity disconnects.
#Click Apply button on the main window

Notes:
*Up to three parameter & value pairs can be entered to this table 
*These values will override the [[GUI]] parameter if the same parameter is available on the GUI. I.e. if parameter 202 ({{param|KVP}}) is overridden, then the GUI parameter has no function.
*This table will be saved to the drive memory if ''Save settings on drive non-volatile memory'' is clicked so override will stay active after drive restart
*To remove override values, enter zeros to the override table row
*If same value is present in on the GUI, it will not change to display the overridden value on Apply click. It will update only when connecting to the drive next time.

==List of parameter addresses and allowed value ranges==
The list of possible parameter can be found at [https://github.com/GraniteDevices/SimpleMotionV2/blob/master/simplemotion_defs.h SimpleMotion V2 library header file]. Parameter numbers have name prefix SMP_ such as SMP_VEL_P which is 202. Note: all parameters may not be available on all devices. 
{{warning|Use caution when changing parameters especially if you don't understand their function throughly}}