Editing SimuCUBE firmware releases
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 616: | Line 616: | ||
* Motor fault codes are read in initialization phase, instead of just checking for success/failure of initialization. | * Motor fault codes are read in initialization phase, instead of just checking for success/failure of initialization. | ||
− | * It is not possible | + | * It is not possible to end up in Operational mode via complex state changes when initial motor settings are not configured at least once via the wizard. |
* Added reading of HV Bus Voltage and FOV values if waited for initialization for more than 30s. FOV must be larger than HV Bus Voltage + 2% for the IONI to init. There is an error message explaining this now. | * Added reading of HV Bus Voltage and FOV values if waited for initialization for more than 30s. FOV must be larger than HV Bus Voltage + 2% for the IONI to init. There is an error message explaining this now. | ||
* Improved resiliency against misconfigured IONI drives, such as bus address offset being other than 0. | * Improved resiliency against misconfigured IONI drives, such as bus address offset being other than 0. | ||
Line 779: | Line 779: | ||
{{Docstatus|wip}} | {{Docstatus|wip}} | ||
− | |||
− | |||
− | |||
− | |||
− |