Editing SimuCUBE hardware requirements
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 27: | Line 27: | ||
|Servo motor | |Servo motor | ||
|1 | |1 | ||
− | | | + | | |
|Recommended at least 15 Nm peak torque for direct drive wheel applications. Check motor specifications the required current. IONI Pro HC can output 25 A (peak of sine) current, which equals 17.7 A RMS current (note that AC motor manufacturers typically give current rantings as RMS value). | |Recommended at least 15 Nm peak torque for direct drive wheel applications. Check motor specifications the required current. IONI Pro HC can output 25 A (peak of sine) current, which equals 17.7 A RMS current (note that AC motor manufacturers typically give current rantings as RMS value). | ||
|- | |- | ||
|Mini USB cables (from USB A to USB Mini B) | |Mini USB cables (from USB A to USB Mini B) | ||
|1-2 | |1-2 | ||
− | | | + | | |
|SimuCUBE has two Mini USB ports, one for USB HID (force feedback interface) and one for [[Granity]] connection. One cable is sufficient but requires swapping cable between the ports during configuration step. Two cables are recommended. | |SimuCUBE has two Mini USB ports, one for USB HID (force feedback interface) and one for [[Granity]] connection. One cable is sufficient but requires swapping cable between the ports during configuration step. Two cables are recommended. | ||
|- | |- | ||
Line 47: | Line 47: | ||
|MMos firmware is available from various internet sites/forums. | |MMos firmware is available from various internet sites/forums. | ||
|} | |} | ||
− | |||
− | |||
− |