Editing SimuCUBE pinouts and wiring
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 103: | Line 103: | ||
===X12-lower=== | ===X12-lower=== | ||
Pin 1 is the left-most. These are active-low with an internal 3.3 kOhm pull-up resistor.<br> | Pin 1 is the left-most. These are active-low with an internal 3.3 kOhm pull-up resistor.<br> | ||
− | Use with a RJ45 (8P8C) modular connector. Can be used with straight unshielded or shielded CAT3/5/5e cables (<b>don't</b> use crossover cables!) | + | Use with a RJ45 (8P8C) modular connector. Can be used with straight unshielded or shielded CAT3/5/5e cables (<b>don't</b> use crossover cables!) |
− | + | ||
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
− | ! Pin number !! Signal name !! STM32F407 pin !! Usage | + | ! Pin number !! Signal name !! STM32F407 pin !! Usage |
|- | |- | ||
− | | 1 || class="inpin" | Button 8|| PE2|| Digital input for button | + | | 1 || class="inpin" | Button 8|| PE2|| Digital input for button |
|- | |- | ||
− | | 2 || class="inpin" | Button 9|| PE3|| Digital input for button | + | | 2 || class="inpin" | Button 9|| PE3|| Digital input for button |
|- | |- | ||
− | | 3 || class="inpin" | Button 10|| PE1|| Digital input for button | + | | 3 || class="inpin" | Button 10|| PE1|| Digital input for button |
|- | |- | ||
− | | 4 || class="inpin" | Button 11|| PE0|| Digital input for button | + | | 4 || class="inpin" | Button 11|| PE0|| Digital input for button |
|- | |- | ||
− | | 5 || class="inpin" | Button 12|| PC12|| Digital input for button | + | | 5 || class="inpin" | Button 12|| PC12|| Digital input for button |
|- | |- | ||
− | | 6 || class="inpin" | Button 13|| PC13|| Digital input for button | + | | 6 || class="inpin" | Button 13|| PC13|| Digital input for button |
|- | |- | ||
− | | 7 || class="inpin" | Button 14|| PC14|| Digital input for button | + | | 7 || class="inpin" | Button 14|| PC14|| Digital input for button |
|- | |- | ||
| 8 || class="powpin" | GND / 0 V|| || Ground|| Ground | | 8 || class="powpin" | GND / 0 V|| || Ground|| Ground | ||
Line 211: | Line 210: | ||
| External || Remove jumper and connect external resistor between '''Resistor Input''' and '''HV BUS Output''' || | | External || Remove jumper and connect external resistor between '''Resistor Input''' and '''HV BUS Output''' || | ||
|} | |} | ||
− | |||
− |