Difference between revisions of "Splitting encoder signal"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
(Created page with "Some times it is necessary to feed encoder signal of motor to two devices: to drive and the motion controller (such as Mesa card in LinuxCNC installation). In such case, the s...")
(No difference)

Revision as of 10:10, 12 May 2015

Some times it is necessary to feed encoder signal of motor to two devices: to drive and the motion controller (such as Mesa card in LinuxCNC installation). In such case, the safest way is to use optoisolators to provide second encoder output that is galvanically isolated from the original signal.

Encodersplitter.png

Splitting encoder signals with isolation. 5V-ISOLATED should be connected to motion controller's 5V supply (powering the optoisolators).

Setup guides Argon user guide Ioni user guide