Editing Testing of drive IO pins
| Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 5: | Line 5: | ||
Step 2. Connect to drive with Granity software and inspect status of the HSIN2 from Testing page status information. | Step 2. Connect to drive with Granity software and inspect status of the HSIN2 from Testing page status information. | ||
| − | + | If all worked correctly, pin state should have changed in Granity. If pin state is stuck, check connections. If still no luck, it is possible that input pin of device has been damaged. | |
| − | + | ||
{{tip|This method works also for analog inputs. Instead, just check analog readings of inputs from Granity. You should see +5V or -5V in this test.}} | {{tip|This method works also for analog inputs. Instead, just check analog readings of inputs from Granity. You should see +5V or -5V in this test.}} | ||
{{tip|For single ended input (ones found in IONI for example), just connect the input with single wire to either 5V or GND.}} | {{tip|For single ended input (ones found in IONI for example), just connect the input with single wire to either 5V or GND.}} | ||
| − | |||
| − | |||
| − | |||
| − | |||
