Editing Using BiSS encoder
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 19: | Line 19: | ||
* No data CRC verification. Suggested workaround is to apply sensible tracking error limits. | * No data CRC verification. Suggested workaround is to apply sensible tracking error limits. | ||
* No daisy chaining encoders is supported. Only one encoder may be connected to a drive. | * No daisy chaining encoders is supported. Only one encoder may be connected to a drive. | ||
− | * No cable delay compensation implemented. Less than 5 meter cable is recommended. | + | * No cable delay compensation implemented. Less than 5 meter cable is recommended, however up to 10 meters have been tested with success. |
== List of tested BiSS encoders: == | == List of tested BiSS encoders: == | ||
Line 110: | Line 110: | ||
# Select corresponding protocol (BiSS B, BiSS C) from {{Param|FBS}} | # Select corresponding protocol (BiSS B, BiSS C) from {{Param|FBS}} | ||
# Set number of MT and ST bits into parameters {{param|FBST}} and {{param|FBMT}} | # Set number of MT and ST bits into parameters {{param|FBST}} and {{param|FBMT}} | ||
− | |||
− | |||
− | |||
− |